Sanus Systems VMCC1 - Manual (Page 9)

ENGLISH
Step 11: Add Speaker Attachments to assembly - Support Bar not installed
Thread a 1/4 - 20 x 3/8 Bolt (j) up through each Upper Extension (a,b) and through the slot in the Axis Bracket (d) and into a 1/4 - 20
Nut (m). Tighten so Upper Extension is secured. See Diagram 11 below.
Note: For Speakers that have threaded inserts that are spaced between 3.75 and 5.7 inches apart the tabs of the Speaker Brackets should
face away from each other. If the threaded inserts on the speaker are spaced between 1.5 and 3.75 inches, the tabs on the Speaker Brack-
ets should face each other. In example shown below, Speaker Brackets are configured for 3.75 to 5.7 inch threaded insert spacing.
Detailed View Diagram 11
d m
a
b
j
Step 12: Add Speaker Attachments to assembly - Support Bar installed
Thread a 1/4 - 20 x 3/8 Bolt (j) up through each Upper Extension (a,b) and into the Bar Bracket (e). Tighten so the Upper Extension is se-
cured to the Bar Bracket. Thread a 1/4 - 20 x 5/8 Bolt (k) up through each of the Upper Extensions. Do not tighten the 1/4 - 20 x 5/8 Bolts
at this time, you will tighten these so they bottom out against the Support Bar after the speaker is attached. See Diagram 12 below.
Note: For Speakers that have threaded inserts that are spaced between 5.7 and 15.5 inches wide, the tabs of the Speaker Brackets should
face each other. If the threaded inserts on the speaker are spaced wider than 15.5 inches, the tabs on the Speaker Brackets should face
away from each other. In Example shown below, Speaker Brackets are configured for the 5.7 to 15.5 range.
Detailed View Diagram 12
e
a,b
j k
VMCC1ins_010606_ML.indd 9 1/16/06 10:32:06 AM