Sharp Aquos LC 20S4U - Manual (Page 15)

14
Press POWER, located on the upper side of the main
unit, to turn on the TV. The SELECT LANGUAGE
screen will be displayed.
Press '/" to select “ENGLISH”, “ESPAÑOL”
(Spanish) or “FRANÇAIS” (French).
E N G L I S H
E S P A Ñ O L
F R A N Ç A I S
Press ENTER to access CH-SETTING mode.
Press '/" to select “ON” or “OFF”. When you select
“ON”, the LCD TV set will automatically memorize the
broadcasting channels.
O N
O F F
A
• If you select “OFF”, EZ SETUP will be canceled.
Press ENTER to access AUTO CLOCK mode.
Press '/" to select “ON” or “OFF”.
When you select “ON”, the LCD TV set will
automatically adjust the clock to search time-signals
(EDS signals), which are provided by some TV stations.
The AUTO CLOCK setting may take from several
minutes to an hour depending on the number of
channels to receive and signal status. If you know the
channel of the EDS signal carrier (PBS or other) in your
area, select “OFF” and follow the procedure in AUTO
CLOCK Setting. (See page 15.)
O N
O F F
■ When you turn on the TV for the first time, it will automati-
cally memorize the broadcasting channels and clock.
Please perform the following instructions before you press
POWER.
(1) Insert the batteries into the remote control. (See page 8.)
(2) Connect the antenna cable to the LCD TV set. (See page 9.)
(3) Connect the AC adapter to the POWER INPUT terminal
of the LCD TV set and plug in the AC cord to the wall
outlet. (See page 10.)
EZ SETUP (With AUTO CLOCK Setting)
EZ SETUP during the First Power On
POWER
1
2
3
Press ENTER to access START EZ SETUP mode.
Press '/" to select “YES”, and press ENTER.
A
• If you want to stop the EZ SETUP process once it has
started, press MENU and it will be canceled. If you want to
set up again, please refer to page 24 on CH-SETTING.
Y E S
N O
C O N N E C T A N T E N N A
O R C A B L E .
The tuner will automatically search for the broadcasting
and cable TV channels. (The channel number will
automatically increase when it appears.)
P L E A S E W A I T
A U T O P R O G R A M M I N G
The LCD TV set will automatically switch to searching
for EDS signals.
If EDS signals are received, the channel number and time will
be displayed, and then the screen shown in step 5 appears.
P L E A S E W A I T
N O W S E A R C H I N G T I M E
Once EZ SETUP is completed, the lowest channel
number memorized will be displayed.
S T E R E O
S A P
M O N O 1 1 : 5 3 A M
2
A
• Do not let the EZ SETUP screen remain unattended for a long time.
• If EZ SETUP does not memorize all the channels in your region,
please refer to page 24 for more information on manually memo-
rizing the channels using CH-SETTING.
• It may be difficult to preset when the broadcasting signals are
weak, the channel cycle frequency is incorrect or the frequency
jamming is occurring around the area. Please refer to page 24 for
more information on manually memorizing channels using
CH-SETTING.
• If there are no channels with EDS signals or the antenna signal is
weak, the AUTO CLOCK setting may not operate. In this case, a
“EDS CH IS NOT AVAILABLE.” message will appear and the
mode will change to MANUAL CLOCK setting. Refer to page 16 to
set the clock manually.
4
5
LC-20S4U_E_P14-20.p65 04.12.14, 1:14 PM 14