Stanton SA-12 - Manual (Page 2)

P L E A S E R E A D C A R E F U L L Y B E F O R E U S E
FAILURE TO FOLLOW THE INSTRUCTIONS PRINTED BELOW MAY VOID WARRANTY
• Follow all security advice printed on your mixer
• When removing the unit's AC plug from the power source, grasp and pull
the plug, NEVER the cord itself!
• Avoid placing your mixer near heat sources, such as power amplifiers.
• When in use, place your mixer on a stable surface, away from vibration.
Always use care when carrying your mixer. Impact, or heavy vibration may
compromise the unit's mechanical integrity. The manufacturer is not
responsible for damage resulting from an impact, or misuse.
• When in use, place your mixer away from sources of hum or noise, such as
transformers, or electric motors.
• To prevent overheating, always provide your mixer with adequate
ventilation air space.
• Avoid stepping on your mixer's AC cord. Repeated compression of the cord
may lead to electrical shorting.
• To avoid damage due to AC voltage peaks, always disconnect your mixer
from the power source during electrical storms. If possible connect mixer to
a surge protector.
• Your mixer contains no user-serviceable parts. The manufacturer is not
responsible for any damage or personal injury resulting from unauthorized
user-servicing or modifications. In addition, the warranty will be void if any
unauthorized service by the user is detected. Always return your mixer to
an authorized Stanton dealer for servicing.
Thank you for making Stanton your first choice in professional DJ mixers.
This innovative family of mixers has been developed with input from the
professional DJ community, bringing to the marketplace a previously
unavailable, affordable combination of user-friendly, functional design,
rugged construction, and professional quality features.
Stanton and your authorized Stanton dealer are dedicated to your complete
satisfaction by offering benchmark service and support throughout the long
life of your Stanton product.
Again, we appreciate your patronage, and look forward to many years of
making music together.
TECHNICAL SPECIFICATIONS
Line inputs: 2 (RCA), -10dBV @ <10Kohm
Phono inputs: 2 (RCA), -50dBV @ <10Kohm
DJ mic input: 1 (1/4 inch), 2.45 mV / 3K ohm
Master output: 2 (1/4” TRS Balanced/RCA unbalanced),
Balanced 4dBu into 10Kohm
Unbalanced: -10dBV into 10Kohm;
Headphone output: 1 (1/4 inch), 1 Minijack (1/8 inch) 32 - 200 ohms
recommended
Frequency Response:
20 Hz - 20 kHz, +0 dB
Tone Control : + 9 / Kill dB (Hi, Mid, Low)
Mic Tone: Hi/Lo +/-10 dB
Dynamic Range: line 90dB, phono 85dB
S/N Ratio: 75dB
Phono EIN: 105 dB
Dimension (LxWxD): 14.9" x 10.5" x 4.3"
379mm x 266.5mm x 109mm
Weight: 8 lbs (3.6 Kg)
REPLACEMENT PARTS
To replace the cross or channel faders, follow steps 1 and 2 of the
cleaning instructions. The following replacement parts are available
from Stanton or your local Stanton dealer.
LF-SK2 Channel input fader
CF-PG110 Penny & Giles
CF-F2
Focus Fader V2
OS2 Optical Scratch switch
phono/line selector
SHP0531 (top) SHP0532 (btm) PROTEKT™ panel
PS-SA12US US Power
Supply (110v)
PS-SA12EU European Power
Supply (220v)
PS-SA12UK UK only Power
Supply (240v)