Swann MWMA170510E SW351-WMA - Manual (Page 3)

3
Changing Batteries
Each of the three devices - the mat, the doorbell and the chime unit - are powered by batteries.
The mat and the doorbell each require a 12V A23 battery.
The chime unit requires 3 x AA cells (for a total of 4.5V).
Changing the Chime Tone
You can set the chime unit to emit one sound when the doorbell is pressed, and a different tone when
someone steps on the mat. This is useful if you use the mat and doorbell for different entrances - each
one can have it’s own sound!
DIP Switches and Jumper Settings
Jumpers control the wireless frequency which the doorbell and mat use to communicate with the chime
unit. For the system to function correctly, the mat, doorbell and chime unit must have the same
arrangement of jumpers. The default configuration is for all jumpers to be closed (that is, they have
the black clip attached).
The DIP switches change the tone which the Chime Unit will sound when the mat or doorbell is
triggered. The sounds that you can choose from, and the arrangement of switches to access them are:
To access the battery compartment, jumper pins and DIP switches of the Wireless Mat control
unit:
Remove the Wireless Mat control module from the small pouch. 1.
Insert a screwdriver or similar into the locking tab on the top of the doorbell casing, and press 2.
down to release the locking tab.
The battery is located at the base of the control module. The jumper pins and the DIP switches
3.
are located immediately above.
To access the battery, jumper pins and DIP switches
inside the doorbell:
Insert a screwdriver or similar into the locking tab 1.
on the top of the doorbell casing, and press down
to release the locking tab.
Remove the doorbell from the rear plate. The
2.
jumpers, DIP switches and battery are located
within.
To access the jumper pins in the Chime Unit:
Locate the jumper compartment cover on the rear of 1.
the chime unit - it’s the small compartment above and
slightly left of the battery compartment.
Using a small Phillips-head screwdriver, remove the
2.
screw and lift the compartment cover. The jumpers are
located within.
Note that there are no DIP switches in the chime unit.
3.
3
Operation
Jumper Pins DIP Switches
None
Church Bells Classic Doorbell
Loud Bell ON
1 2
ON
1 2
ON
1 2
ON
1 2
ON
1 2
ON
1 2
ON
1 2
ON
1 2
Jumper Pins