Sony CMT-EP50 - Manual (Page 7)

Getting Started
7
Setting the time
1
Turn on the system.
2
Press CLOCK/TIMER on the remote.
When you set the clock for the first time, go
to step 5.
3
Press CLOCK/TIMER on the remote
repeatedly until “SET CLK” appears in
the display.
4
Press TUNER MEM/ENTER on the
remote.
5
Press TUNING/CLOCK/TIMER + or – on
the remote repeatedly to set the hour.
6
Press TUNER MEM/ENTER on the
remote.
7
Press TUNING/CLOCK/TIMER + or – on
the remote repeatedly to set the minute.
8
Press TUNER MEM/ENTER on the
remote.
To reset the system clock
Start over from step 1.
Note
The clock settings are canceled when you disconnect
the power cord or if a power failure occurs.
Jack type B
3 Connect the power cord to a wall outlet.
If the supplied adaptor on the plug does not
fit your wall outlet, detach it from the plug
(only for models equipped with the
adaptor).
To turn on the system, press [/ 1 (power).
Inserting two size AAA
(R03) batteries into the
remote
Tip
When the remote no longer operates the system,
replace both batteries with new ones.
Note
If you do not use the remote for a long period of time,
remove the batteries to avoid possible damage from
battery leakage.
AM loop antenna
Extend the FM lead
antenna horizontally.
FM ANT
75
Ω
CO AXIAL
AM ANT