Sunrise Medical Trapeze IC-7740 - Manual (Page 2)

E n g l i s h E n g l i s h 3 2
ASSEMBLING FLOOR STAND (Figure 2)
1. Place the “A” frame into the floor stand leg assembly with the snap buttons
facing the short length of the floor stand.
2. Press the snap button on one leg of the “A” frame and slide it into the leg
assembly until it snaps into place.
3. Make sure the snap buttons fully protrude through the holes in the leg assembly.
4. Attach Trapeze to floor stand.
• The Fixed Trapeze should ONLY be used on beds with metal-framed
headboards.
• The Head Trapeze, used in conjunction with a bed, can support an
individual weighing up to 250 lbs. (114 kg.).
• The Fixed Trapeze is designed to provide support, increase stability
and assist the user when repositioning himself/herself in bed. The
Fixed Trapeze is NOT designed to support the total weight of an
individual.
• Do NOT install or adjust Trapeze when bed is occupied.
• Do NOT attach swivel Trapeze to the floor stand. This may cause the
stand to tip over, causing injury to the user and/or assistant.
• Before lowering bed, ensure trapeze is in the highest position.
• Make sure the snap buttons fully protrude through the adjustment
holes of the floor stand. This insures that the floor stand is properly
installed and securely locked in position.
• After installation and BEFORE use, make sure all attaching hardware
is tight and secure.
• The trapeze is not intended to provide a mounting point for either
powered or non-powered traction equipment.
ATTACHING TRAPEZE TO BED END (Figure 1)
1. Locate the lower bed bracket and attach to the underneath of the bed head-
board. The tubular hook on the bracket should face up.
2. Tighten the wing nuts to secure the bracket in place.
3. Place the Trapeze on a flat surface for easy installation of the upper bed bracket.
4. Loosen the wing nuts on the upper bed bracket and slide the bracket 3/4 of the
way up the Trapeze bar. Once in position, tighten the wing nuts to secure.
5. Place the Trapeze bar assembly into the socket of the lower bracket now secured
on the bottom of the bed headboard.
6. Position the upper bracket so its tubular hook rests on the top of the bed head-
board. Tighten the wing nuts to secure the bracket in place.
Wing nut
Upper bed
bracket
Tubular hook
Socket
Tubular hook
Key Clamp
“S” hook
Links
Figure 1
Wing nut
Lower bed
bracket