Controls & operation, Warning, Fuel and oil mixture – Snapper 520E EN User Manual

Page 12: Proper fuel mixing procedure

Advertising
background image

11

FUEL AND OIL MIXTURE

The snowthrower uses a two cycle engine that requires a
mixture of fuel (gasoline) and oil for lubrication of engine
bearings and other moving parts.

The correct fuel/oil mixture ratio is 50 to 1. Use fuel/oil
mixture chart shown.

NOTE: To prevent damage to engine, carefully
observe recommended fuel to oil mixing ratio and
procedures.

• Gasoline and oil must be premixed in a clean fuel

container.

• Always use fresh, unleaded, winter grade fuel.

• Never put plain, unmixed fuel into fuel tank. Shake

fuel container each time before filling fuel tank.

• Never use “stale” fuel left over from last season or

stored for long periods.

• DO NOT USE MULTI VISCOSITY OILS, SUCH AS

10W-30 or 10W-40.

PROPER FUEL MIXING PROCEDURE

1. Fill approved clean fuel container one quarter full with

fresh unleaded fuel - one quart (one liter) in a one
gallon (4 liter) container.

2. Pour recommended amount of high quality two

cycle oil — 2.5 ounces (80 ml) into fuel container for
one gallon (4 liters) of fuel. (NOTE: DO NOT USE
MULTI VISCOSITY OILS, SUCH AS 10W-30 or
10W-40.)

3. Reinstall cap on the fuel container and shake con-

tainer vigorously so oil mixes with gasoline.

4. Unscrew cap and fill container with fuel. Shake con-

tainer again.

5. Remove fuel tank cap and carefully pour mixed fuel

into the fuel tank, filling to 1/2 inch (1.5 cm) below
filler neck to allow room for expansion. Never put
plain, unmixed fuel into fuel tank. Shake fuel con-
tainer each time before filling fuel tank.

Controls & Operation

Gasoline is highly flammable and must be
handled with care. Follow these fuel handling
precautions:

• Use an approved fuel container.

• DO NOT run the unit indoors. DO NOT fill fuel

tank indoors or while engine is running.

• Allow engine to cool for at least ten minutes

before refueling.

• Wipe up any spilled fuel before starting the

engine.

• Fuel vapors can travel to distant ignition

sources. Keep fuel and fuel vapors away from
ignition sources.

WARNING

FUEL TO OIL MIXTURE CHART (50:1)

U.S.

Imperial

Metric

Gasoline 2 Cycle Oil Gasoline 2 Cycle Oil Gasoline 2 Cycle Oil

Gallons

Ounces

Gallons

Ounces

Liters

Milliliters

1

2.5

1

2.8

4

80 ml

2

5

2

5.6

8

160 ml

5

13

5

14.1

20

400 ml

Figure 7. Proper Fuel Mixing Procedure
A. Fill Container with 1 Quart (1 Liter) of fuel
B. 2.5 Ounces (80 ml) of two-cycle oil
C. Combine in container, then shake container
D. Additional fuel brings total to 1 Gallon (4 liters)

A

B

D

C

Advertising
This manual is related to the following products: