Samsung HT-X40 - Manual (Page 12)

ENG
23 22
OPERA
TION
Before Using Your Home Theater
To Operate your Samsung TV and the Home Theater with the HT-X40's Remote Control
1 Plug the main unit's power cord into the AC power supply.
■ Before plugging your system into a main socket, you must check the voltage setting
(OPTIONAL). If the voltage of the socket does not correspond to the setting on the rear of
the unit, you may seriously damage your system.
2 Press the TV button to set the remote to TV mode.
3 Press the POWER button to turn on your Samsung TV
with this remote.
4 Press the TV/VIDEO button to select VIDEO mode on your TV.
5 Press the DVD RECEIVER button to switch to DVD RECEIVER mode to
operate the DVD Home Theater
6 Press the FUNCTION button on the main unit or DVD button
on the remote to enable DVD/CD playback.
1 Press the OPEN/CLOSE button to open the disc tray.
2 Load a disc.
■ Place a disc gently into the tray with the disc’s label facing up.
3 Close the compartment by pressing the OPEN/CLOSE button again.
■ Playback starts automatically.
• Depending on the content of the disc, the initial screen may appear different.
• Any piracy could not be runnable in the player. Otherwise, it violates the CSS (Content Scrambling System : a copy protection
system) recommendations.
To stop playback, press the STOP ( ) button during playback.
■ If pressed once, <PRESS PLAY> is displayed and the stop position will be stored in memory.
If the PLAY/PAUSE ( ) button or ENTER button is pressed, playback resumes from the stop position.
(This function works only with DVDs.)
■ If pressed twice, < STOP > is displayed, and if the PLAY/PAUSE ( ) button is pressed, playback starts from the
beginning.
To temporarily pause playback, press the PLAY/PAUSE ( ) button during playback.
■ To resume playback, press the PLAY/PAUSE ( ) button again.
VIDEO
The DVD Home Theater's remote can be used to control Samsung TVs.
Disc Playback
DVD CD
X40(1~39P) ENG_CA 2007.3.11 1:26 PM Page 22