Samsung HL-P6163W - Manual (Page 9)

16 17
Connections
Connecting VHF and UHF Antennas
If you do not have a cable system, you will need to connect an antenna to your TV.
Antennas with 300-ohm Flat Twin Leads
If your antenna looks like this: it has 300-ohm flat twin leads.
1 Place the wires from the twin
leads under the screws on the
300-75 ohm adaptor (not
supplied). Use a screwdriver
to tighten the screws.
2 Plug the adapter into the
“ANT 1 IN” terminal on the
rear panel.
Antennas with 75-ohm Round Leads
If your antenna looks like this: it is an antenna with 75-ohm round leads.
1 Plug the antenna lead into the
“ANT 1 IN” terminal on the
rear panel.
Separate VHF and UHF Antennas
If you have two separate antennas for your TV (one VHF and one UHF), you must combine the
two antenna signals before connecting the antennas to the TV. This procedure requires an optional
combiner-adaptor (available at most electronics shops).
1 Connect both antenna
leads to the combiner.
2 Plug the combiner into the
“ANT 1 IN” terminal on
the rear panel.
BP68-00283A-02(14~23) 5/6/04 11:30 AM Page 16