Sony UP-CX1 - Manual (Page 5)

Installing the Printer Driver
5
Windows 2000
Printer Driver Installation Under
Windows XP
1
Connect the UP-CX1 series printer (one only) for
which the driver is to be installed to the computer.
2
Turn power to the connected UP-CX1 series printer
on.
3
Turn power to the computer on, and log on as the
system administrator or a member of the
Administrators group.
The [Found New Hardware Wizard] appears.
• If the [Found New Hardware Wizard] screen
looks like that shown in step 3, proceed to step 4.
• If the [Found New Hardware Wizard] screen
looks different from that shown in step 3, proceed
to step 5.
• If the [Found New Hardware Wizard] screen does
not appear, perform the steps described below,
with the UP-CX1 series printer for which the
printer driver is to be installed turned on and
connected to the computer. (Any other USB
printers or previously installed UP-CX1 series
printers should not be connected at this time.)
1 Click [Start] and select [Control Panel].
2 Double-click [System].
The [System Properties] dialog box opens.
3 Click the [Hardware] tab.
4 Click [Device Manager].
The [Device Manager] window opens.
5 Click [+] at the left of [Universal Serial Bus
controllers].
6 Select [USB Printing Support], right-click
and open the Properties. Confirm that [UP-
CX1] is selected for [Location], and then
select [Uninstall] from the [Action] menu.
7 Restart the computer.
The [Found New Hardware Wizard] appears.
4
Click [No, not this time] and click [Next].
5
Select [Install from a list or specific location
(Advanced)], and then click [Next].
The screen changes as follows.
6
Select [Search for the best driver in these locations],
select [Search removable media (floppy,
CD-ROM)], and then insert the supplied CD-ROM
“PRINTER DRIVER & INSTRUCTIONS FOR
USE UP-CX1” into the CD-ROM drive.
7
Click [Next].
The following dialog box appears.