Smart Technologies Interactive Whiteboard System 480i5 - Manual (Page 53)

4. Ensure that the projector lamp is installed securely.
5. Confirm that your projector is turned on and that the projector status lights are illuminated. If the
status lights display unusual behavior, see Projector lights and status on page 36 to
troubleshoot your system.
Partial, scrolling or incorrectly displayed image
N
N O T E S
l
The following procedure applies to Windows® 95, Windows 98, Windows 2000 and
Windows XP operating systems on desktop computers only.
l
This procedure may vary depending on your version of Windows operating system and your
system preferences.
g To resolve a partial, scrolling or incorrectly displayed image
1. Select Start > Control Panel.
2. Double-click Display.
The Display Properties window appears.
3. Click Settings.
4. Verify that your display resolution setting is equal to 1024 × 768.
5. If the projector still does not display the entire image, perform the following procedure to change
the monitor display.
g To change the monitor display
1. Click Advanced Properties.
2. On the Monitor tab, click Change.
3. Click Show all devices, and then select Standard monitor types from the list.
4. In the Models list, select the resolution you need.
5. Verify that the resolution setting of the monitor display is equal to 1024 × 768.
Unstable or flickering image
If the projector’s image is unstable or flickering, you could have different tracking settings on your
input source.
C H A P T E R 6
Troubleshooting your interactive whiteboard system
43