Seagate BARRACUDA 9 ST19171WD - Manual (Page 38)

36 Barracuda 9 Installation Guide, Rev. B
W/WD drives
W/WD drives section Setting the SCSI ID jumpers
Use the J6 jumper block to set the SCSI ID (Figure 9). To change
the SCSI ID, install jumpers on the appropriate pins as shown in
the illustration. Optional connections to switching circuits in host
equipment are provided on J1 auxiliary to set the SCSI ID (see
Figure 10).
Figure 9. Setting the SCSI ID
A2 A3 A1 A0
SCSI ID = 0
(default)
SCSI ID = 1
SCSI ID = 2
SCSI ID = 3
SCSI ID = 4
SCSI ID = 5
SCSI ID = 6
SCSI ID = 7
Reserved
L
E
D
R
E
S
SCSI ID = 8
SCSI ID = 9
SCSI ID = 10
SCSI ID = 11
SCSI ID = 12
SCSI ID = 13
SCSI ID = 14
SCSI ID = 15
Jumper Plug
(enlarged to
show detail)
J6
Drive
Front
Pin 1