Sharp Model AFT - Manual (Page 7)

New 2/98. Minor revision 7/99
Part No. 2H2412 Kodak and Ektagraphic are trademarks. Printed in U.S.A.
Operation
The KODAK EKTAGRAPHIC III AFT Projector is
equipped with controls to adjust the FADE and VIEW
cycles. They are located under the projector handle. It is
shipped with factory default settings of:
·
AUTOMATIC AFT mode - ON ( I )
· VIEW time - 10 seconds
· FADE Up and Down - 0.5 second each (total
1 second)
To use:
1. Install a loaded slide tray.
2. Turn the slide projector ON by selecting low or high lamp position on the control panel.
3. The projector will automatically advance slides, fading between slide changes, and will continue until
the projector is turned off.
To adjust VIEW control:
Using a small, flat-blade screwdriver, turn the VIEW screw clockwise or counterclockwise to increase or
decrease the amount of time you want the image projected (5 to 15 seconds).
To adjust FADE control:
Using a small, flat-blade screwdriver, turn the FADE screw clockwise to fade up and down (0.5 to
4 seconds). Total fade time is two times your selection.
NOTE: You may make these adjustments with the projector lamp either ON or OFF.
To turn off AFT mode:
Using a flat-blade screwdriver, move the Automatic AFT mode to the OFF ( O ) position. The projector can
now be used as a standard EKTAGRAPHIC III A Projector. Should you need a user manual for this model,
you can obtain one by calling the Kodak Information Center in the U.S. at 1-800-242-2424, or in Canada at
1-800-465-6325.
Tips
· Keep the operating environment clean; dust and dirt can negatively impact operation.
· To help maximize projector performance, clean the projector regularly following the maintenance
instructions included here.
· Keep extra lamps on hand.
· Have an extra lamp module on hand for quick lamp change. It only takes a few seconds to change a
lamp module, but it could take a while for a lamp to cool enough to change the lamp itself!
· For cooler operating temperature and longer lamp life, use an FHS lamp designed for use with
KODAK EKTAGRAPHIC Slide Projectors. If you wish to purchase this lamp, ask your local dealer to
order CAT No. 147 7678.
· Note your local dealer and service organization telephone numbers here for quick reference.
Local Kodak Dealer: _____________________________________________________________
_____________________________________________________________________________
www.kodak.com/go/projectors