Swann NetSlider II - Manual

READ THIS FIRST
NetSlider II
Thank you for purchasing a NetSlider II modem.
Now you can discover the Internet using the latest V.90 technology at speeds up to 56k.
PACKAGE CONTENTS: MINIMUM SYSTEM REQUIREMENTS:
• NetSlider II modem
• Swann NetTools CD
• RJ-11 Phone Cable •10V AC Power Supply
•Serial Cable • 486 or faster processor (Pentium recommended)
• 16MB Ram (32MB recommended)
• Microsoft Windows 95 or higher
• Spare serial port (16550 UART)
® ®
Step 1: Install the drivers
Make sure all other programs are closed, and click on the Netslider II driver installation icon.
A new window will open prompting you with the options to download the file, or run this program from its current location. Select run from current location and
click ok.
You may get a warning that the Authenticode Signature is not found. You must click yes to continue with the installation. Please note that all files have been
scanned with the latest version of Computer Associates VET antivirus program.
Once you have clicked yes, another window will inform you that you are about to install the Netslider II modem, click ”install”to continue.
You will now see the Licence agreement window open. Read this carefully, and then click “I agree” to continue with the installation.
The necessary drivers will now be copied to your systems hard disk, in the Windows\inf folder. This is where Microsoft Windows stores all the information files
for your hardware. Once this is done most hardware will be detected and installed automatically by Microsoft Windows and also added to the list of
manufacturers that you can select from. You will also see a shortcut on your Start Menu to uninstall the drivers should the need arise.
Once you have completed the driver installation, you will need to shut down your computer and follow step 2 on the page below.
® ®
® ®
There are two methods of installing the Swann Netslider II modem, the easiest is to follow the instructions as described in step 1 and 2 below, then shut down
your computer, connect and turn on your modem, then restart your PC. Once your computer starts, your operating system will detect your new hardware and
install the necessary drivers.
The second method is to connect your modem first, then switch on your PC. Once the new device is detected, you can install the Netslider II modem driver by
selecting your CD-ROM drive from the install locations in the “add new hardware wizard”.Microsoft
Windows NT users can also use this location to install the
Netslider II manually.
The drivers for your modem are also located in d:\drivers\ns2e (where d represents the letter assigned to your CD-ROM drive).
If you are required to do a completely manual installation (eg Microsoft Windows NT users) the modem can be installed manually by running the driver
installer on this page, and then using the Modems control panel applet to select Swann Communications from the list of manufacturers. Once Swann is selected
you will be able to select your modem model and continue the installation including selecting the serial port to which it is connected.
The Netslider II has been tested, and is compatible with Microsoft Windows 95, 98, 98SE, ME, NT and 2000.
® ®
® ®
® ®
Installation Guide