Shopsmith DustCollector - Manual (Page 7)

Page 7
330002 Dust Collector
General Information
Dust Collector Attachment Kit:
10. Two Hoses - Connect to the 3-way inlet.
11. Two Inlet Plug Assemblies - Placed in
the 3-way inlet port(s) that are not in use.
12. Two Extension Wands
13. Floor Pickup
14. Elbow Brush
15. Reducer - Allows you to connect the Shopsmith
Mark V Model 500 (sold separately).
16. Utility Pickup
Specifications
The Dust Collector’s specifications will give
you an idea of its capabilities.
Bag: _________ 30 gallon capacity
Motor: _______ 1/2 hp industrial-duty ca-
pacitor start.
Power Cord: __ 12' long
Airflow: ______ 330 cfm
Dimensions: __ 21" wide x 26" long x 48" high
Weight: ______ approximately 64 pounds
Figure 3
Terms to Know
The main parts of the Dust Collector are:
1. Bag - A heavy duty, disposable, 30-gal-
lon, 4 mil., clear plastic bag.
2. 3-Way Inlet - Allows the hookup of one
2-1/2" diameter hose, or you can use two
or three hoses simultaneously.
3. Filter Hood - Filters dust particles out of
the air and returns dustfree air to the
room. An adjustable retaining strap se-
cures it to the main housing.
4. Rear Handle - Easily accessible for move-
ment of the unit.
5. Power Switch - A rocker type on/off
switch with an internal dust seal for extra
safety.
6. Main Housing Assembly - Contains the
motor and blower assembly.
7. Bag Clips - Three clips hold the bag
while the retaining strap is being attached.
8. Retaining Strap - Secures the bag to the
main housing.
9. Base Pan - Supports the unit. Two front
casters and two rear wheels are attached
for easy mobility.