Troubleshooting chart, Re fere nc es, General " tuner " remote control – Sharp SD-AT50 User Manual

Page 54: E-49

Advertising
background image

E-49

SD-AT50(U)E5.fm

02/7/19

SD-AT50

ENGLISH

DX-AT50

Re

fere

nc

es

- Tr

oubleshooting cha

rt -

Troubleshooting chart

Many potential problems can be resolved by the owner without calling a service tech-
nician.
If something is wrong with this product, check the following before calling your autho-
rized SHARP dealer or service center.

" General

" Tuner

" Remote control

Symptom

Possible cause

Reference

page

No sound is heard.

!

Is the volume level set to "0"?

P. 18

!

Are the headphones connected?

P. 28

!

Are the speaker wires disconnect-
ed?

P. 12

!

Is the speaker size set to NO (OFF)?

P. 41

The sounds from speakers
are not well balanced.

!

Are the speaker cords connected to
the wrong channels?

P. 12

!

Is each speaker placed at the same
distance from the listener?

P. 16

!

Are speakers adjusted to the same
level?

P. 42

Noise is heard during play-
back.

!

Move the system away from any
computers or mobile phones.

When a button is pressed,
the system does not re-
spond.

!

Set the system to the power stand-
by mode and then turn it back on. If
the system still malfunctions, reset it.

P. 50

Interference or noise occurs
on the TV image.

!

Is the system placed near TV with in-
ternal antenna? Use an outdoor an-
tenna.

P. 13

Timer playback does not
start.

!

Did you remove the plug from the
wall jack, or did a power failure oc-
cur?

P. 24

The display on the system is
dark.

!

Hold down the DISPLAY button on
the remote control for 2 seconds or
more to select "ON".

P. 18

The power is not turned on.

!

Is the system unplugged?

P. 18

!

Is the system connection cord (for
DVD player) disconnected?

P. 11

!

The protection circuit may be acti-
vated. Unplug and plug in the power
cord again after 5 minutes or more.

P. 50

Symptom

Possible cause

Reference

page

The sound is not reproduced
in the Dolby Digital 5.1 ch.

!

Is the initial setup screen set to
"DPCM"? Change it to "BIT-
STREAM".

P. 20

No images are displayed.

!

Is TV turned on?

P. 47

!

Is the input of TV switched?

P. 47

Symptom

Possible cause

Reference

page

Radio makes unusual noise
consecutively.

!

Is the system placed near the TV or
computer?

P. 13

!

Is the FM antenna or AM loop anten-
na placed properly? Move the an-
tenna away from the AC power cord
or the system if located near.

P. 13

Symptom

Possible cause

Reference

page

The remote control does not
operate properly.

!

Is the battery polarity respected?

P. 17

!

Are the batteries dead?

!

Is the distance or angle incorrect?

P. 17

!

Are there any obstructions in front of
the AV control unit?

!

Is the remote control sensor ex-
posed to strong light (inverter fluo-
rescent light, direct sunlight, etc.)?

P. 17

!

Is the remote control for another
equipment used simultaneously?

!

Are buttons on the front and back
faces of the remote control pressed
simultaneously?

The system cannot be turned
on with the remote control.

!

Are the AC power cords of the DVD
player and the subwoofer/amplifier
unit plugged in?

P. 18

!

Are the batteries inserted?

P. 17

Advertising
This manual is related to the following products: