Salton, Inc JE-1013 - Manual (Page 9)

How to Clean
1. Move the Control Switch to the Off position and wait for the motor
to stop completely.
2. Unplug from the wall outlet.
3. Disassemble the Juicer (see directions on page 8)
4. Clean the Pulp Container, Pulp Chute/Juicer Cover, Food Pusher, Stainless
Steel Juice Collector, Juice Jug and Froth Separator in warm, soapy water.
A mild detergent is recommended. Rinse well and dry thoroughly.
NOTE: Care must be taken when cleaning or storing the Pulp
Container with Safety Foot.
5. Hold the Stainless Steel Strainer Basket/Cutting Blades under clean
running water. Use the cleaning brush included with the Juicer to gently
clean away pulp from the filter and cutting blades. Rinse under running
water. Hold the Strainer Basket/Cutting Blades up to the light to ensure
that the fine mesh holes are not blocked. If the holes are blocked, soak
the Strainer Basket/Cutting Blades in hot water to loosen the pulp and
clean with the nylon brush again. Allow to dry on a cloth or paper towel
before reassembling the juicer.
CAUTION: THE CUTTING BLADES ARE VERY SHARP.
6. Wipe the Motor Housing with a soft cloth moistened in warm soapy
water. NEVER IMMERSE MOTOR HOUSING WATER OR ANY
OTHER LIQUID.
9