Sharp VIEWCAMZ VL-Z5E - Manual (Page 37)

Basic Operations
27
Note:
• If you press the Start/Stop button in Tape
Playback mode, the “g” mark appears and
the camcorder enters Recording Standby
mode. If you do not intend to record, press
l
to turn the “g” mark off, then press m to
begin playback. This will ensure your
previous recording is not erased (see pages
64–67).
To stop playback
Press l.
To turn the power off
Set the Power switch to OFF without
pressing the Lock button.
Note:
• The tape automatically rewinds when
playback reaches the end of the tape.
Watching the playback in
the viewfinder
You can also watch the playback in the
viewfinder by closing the LCD monitor with
the screen facing in. You cannot monitor the
sound through the speaker when watching
the playback in the viewfinder.
Tape Playback
Available mode:
Tape Playback
The LCD monitor screen functions as a
handy playback monitor. Nothing needs to
be connected, allowing instant on-screen
playback with the sound through the built-in
speaker.
1
Set the Media Selection
switch to V.
2
Hold down the Lock
button and set the
Power switch to w.
3
Press j (or k) on the Operation
button to rewind (or fast forward) the
tape to the desired point.
4
Press m to begin playback.
Basic Operations
Playback
Power switch
Operation button
Lock button
Media Selection
switch