Subaru Impreza 2.2L MT - Manual (Page 42)

IMPREZA U.S.A. (E)
1
Doors and locks
1-11
– CONTINUED –
J
Adding or deleting remote transmitters
Up to four (4) transmitters can be programmed to your keyless entry sys-
tem.
NOTE
Make sure no one else is operating another keyless entry or security sys-
tem within range of your vehicle when you are programming remote
transmitters. Another transmitter code could be inadvertently “learned”
by your system, allowing someone unauthorized access to your vehicle.
B
To program an additional transmitter
1. Open the driver’s door.
2. Turn the vehicle ignition to the “ON” position.
3. Press and hold the Programming button in.
D After approximately 15 seconds, the door locks will cycle 3 times.
This indicates that the system is in the Transmitter Programming
Mode.
Do not release the Programming button.
4. Press the “LOCK” button on the new transmitter. The door locks will
cycle once.
5. Repeat step 4 for any additional transmitters.
6. Exit the Transmitter Program Mode by releasing the Programming
button and turning the vehicle ignition off. Test all remote transmitters
to ensure that they work properly.
B
To delete a lost or stolen transmitter
1. Follow step 1 to 3 as described above.
2. Re-program the remaining transmitters as described in step 4.
D If there is only one remaining transmitter, perform step 4
four
times .
D If there are two remaining transmitters, perform step 4
twice for
each transmitter.
J
System maintenance
Your keyless entry system does not require any specific maintenance
except for occasionally changing the transmitter battery. The 12-volt bat-
tery in the remote transmitter should last approximately one year,
depending on usage. When the battery begins to weaken, you will notice