Siemens PEGASUS-DTC AX72 - Manual (Page 10)

Calling 10
© Sieme
ns A
G
2003, C:\Dat
en
_i
tl\Si
emens\D
TP-
Satz\Pr
odukt
e\AX72
_P
eg
asus_D
TC
\o
ut-
left page (10) of AX72 Pegasus-DTC, FUG, en, A31008-H2860-A1-1-7619 (06.10.2005, 08:28)
VA
R Language:
en; V
A
R is
sue dat
e: 05
0613
Change phonecode
You define the phone code (4-8 digits)
when you call up a protected function for
the first time. It is then valid for all phone-
code protected functions. If the wrong
code is entered three times then the
phone will be locked. Contact Siemens
Customer Care for instructions on how to
unlock your pone.
Clear SIM card barring
If the PIN is entered incorrectly three
times, the SIM card is barred. Enter the
PUK (MASTER PIN), provided by your serv-
ice provider with the SIM card, according
to instructions. If the PUK (MASTER PIN)
has been lost, please contact your service
provider.
Preventing accidental activation
Even if PIN control is deactivated confir-
mation is required to switch on the phone.
This prevents the phone from being
switched on accidentally, e. g. when car-
ried in a pocket or whilst you are on an
aircraft.
Press and hold the On/Off/End key
B
and confirm with §OK§ . The phone
switches on.
Calling
Dialling with number keys
The phone must be switched on (standby
mode). Dial number (always with area
code, if necessary with international dial-
ling code). To dial international dialling
code press and hold
0
until a "+" is dis-
played. Press §+List§ and select country.
Short press §Clear§ to clear the last digit, a
long press clears the entire phone
number. To dial press the Call key
A
.
End call
Press the End key
B
briefly. Press this
key even if the person on the other end of
the line has hung up first.
Set volume
Use navigation key
E
to start adjusting
the volume during conversation. Set vol-
ume with navigation key
G
.
If a Car Kit is used, its volume setting will
not affect the usual setting on the phone.
Redial
To redial numbers that were dialled previ-
ously, press the Call Key
A
once, pick up
the required phone number from the list
with
G
, then press
A
again.
If the number is busy
Press §Auto dial§ for automatically dialling
the phone number ten times at increas-
ing time intervalls or press §Call back§ (
L
)
for phone ringing when the busy number
is free. Press §Prompt§ and a beep reminds
you to redial the dispayed phone number
after 15 minutes.
Accept call
The phone must be switched on (standby
mode). An incoming call will interrupt
any other use of the phone. Press §Answer§
or
A
.
Please make sure you have accepted the call
before holding the phone to your ear. This will
avoid damage to your hearing from loud ring
tones!