Smeg IG40521X2 - Manual (Page 27)

User instructions
54
If the dishes fail to dry or remain dull, check that:
• there is rinse aid inside the special container;
• the rinse aid dispenser setting is correct;
• the detergent used is of good quality and has not lost its
effectiveness (for example, through incorrect storage, with the box
left open).
If the dishes show signs of streaking, staining, etc., check that:
• the rinse aid dispenser setting is not too high.
If there are visible traces of rust inside the tank:
• the tank is made of steel, and therefore any rust marks are due to
external elements (fragments of rust from the water pipes, pots,
cutlery, etc.). Special products are commercially available t o
remove such marks;
• check that the amount of detergent being used is correct. Certain
detergents can be more corrosive than others.
• check that the cap of the salt container is securely closed, and that
the water softening setting is correct.
If after following the above troubleshooting instructions the problem
persists, call the nearest After-Sales Centre.
WARNING: any operations performed on the appliance by
unauthorised persons are not covered by the warranty and shall be
paid for by the user.
TECHNICAL DATA
Width 447 ÷ 449 mm
Depth measured flush with the
outer edge of the control panel Free standing: 600 mm
Semi-integrated: 590 mm
Height Free standing from 850 mm to 870 mm
Semi-integrated from 820 mm to 870 mm
Capacity 9 Standard place settings
Water supply pressure min. 50 – max. 900 KPa (min. 0.5 – max. 9 bar)
Electrical characteristics See rating plate