SMC Networks 16 10BASE-T - Manual (Page 183)

Entering Commands
4-7
4
To enter the Global Configuration mode, enter the command configure in Privileged
Exec mode. The system prompt will change to “Console(config)#” which gives you
access privilege to all Global Configuration commands.
To enter the other modes, at the configuration prompt type one of the following
commands. Use the exit or end command to return to the Privileged Exec mode.
For example, you can use the following commands to enter interface configuration
mode, and then return to Privileged Exec mode
Console#configure
Console(config)#
Table 4-2. Configuration Modes
Mode Command Prompt Page
Line line {console | vty} Console(config-line)# 4-10
Access
Control List
access-list ip standard
access-list ip extended
access-list mac
Console(config-std-acl)
Console(config-ext-acl)
Console(config-mac-acl)
4-85
Interface interface {ethernet port | port-channel id| vlan id} Console(config-if)# 4-104
VLAN vlan database Console(config-vlan) 4-145
Console(config)#interface ethernet 1/5
.
.
.
Console(config-if)#exit
Console(config)#