SIIG 1X4 HDMI 1.3 CAT5E - Manual (Page 3)

3
1 If the HDTV shows video without audio, set audio
mode to stereo
2 Factory default setting is Pin#1 - OFF, Pin #2 OFF,
for 1080p with stereo
3 If you encounter unsolved audio/video output
problem during system installation, please set the
DIP switch to Pin #1 - OFF, Pin #2 - ON to enforce
720p with stereo output to check the system. Also,
make sure to reset your HDMI sources to output
720p
4 Setting at this mode may cause compatibility issues
amongst different HDMI sources and displays. If
you cannot get the audio and/or video output,
change the DIP switch setting to default mode or
safe mode to verify the functionality of the device
5 EDID learning mode - set Pin #1 - ON first then
connect the HDTV set to the HDMI In via HDMI
cable, wait for 20 seconds to complete the EDID
learning process. To learn the EDID of another
HDTV, repeat the process.
Pin#1
Switch Position
Video Description
Up to
1080p
Pin#2
Default mode 2 - up to 1080p & stereo
audio output for most HDTVs
Safe Mode 3 - enforce 720p/1080i video
& stereo audio output for basic
compatibility among HDTVs
Stereo 1
EDID Learning 5 - learning EDID from
the display while playing any received
HDMI audio format
OFF
Bypass 4
Audio
OFF
OFF
OFF
ON
ON
ON ON
Up to
720/1080p
Bypass
Stereo
Bypass 4
Stereo
EDID Learning 5 & Stereo - learning
EDID from the display & enforcing
stereo output
Dip Switch