Samson MDR 1064 - Manual (Page 2)

MDR 1064
PRODUCT SPECIFICATION SHEET
SERIES DESCRIPTION CATEGORY
MDR MIXER MIXERS
Equalization
Hi shelving ......................... +/- 15dB @12kHz
Mid peak ............................ +/- 15dB @2.5kHz
Low shelving ....................... +/- 15dB @80Hz
Low Cut filter ...................... 75Hz, 18dB/oct.
Main Mix Section
Noise (Bus noise) ................ Levels full down: -97dBr
(ref.:+4dBu); Level set to 0
dB: -85dBr (ref.:+4dBu)
Max output ......................... +22dBu balanced XLR,
22dBu unbalanced, 1/4” jacks
AUX Return gain range ........ ∞ to +15dB
AUX Sends max out ............ +22dBu
Power Consumption ............ 15W
Power supply (AC/AC Adaptor)
Main voltage ....................... USA/Canada 108 - 132V, 60Hz
Europe 210 - 230V, 50Hz
U.K./Australia 240V, 50Hz
Physical
Net weight ......................... 6.8 lb. (3.1Kg)
Dimension (W x D x H) ........ 13.5” x 12” x 2.8”
(344mm x 304mm x 71mm)
ARCHITECT’S & ENGINEER’S SPECIFICATIONS
The Samson MDR1064 shall be a 10 input, stereo output
mixer. It shall have 6 mic channels with trim controls,
switchable high pass filter, high frequency, mid frequency,
and low frequency equalizer controls, 2 aux sends, pan
control, level control and LED peak indicators. It shall have
2 line input stereo channels with all the same controls as
the mic channels except for the trim,highpass and the pan
control will be a stereo balance control. A stereo main output
level controls will also be available. A control room and
headphone output and level control shall also be provided.
The MDR1064 uses an external power supply.
71mm
304mm
344mm
MDR 1064 SPECIFICATIONS
Mono input channels
Microphone input ................ electronically balanced,
discrete input
configuration
Frequency response ............ 10Hz to 50kHz, +/-0.4 dB
Distortion ........................... (THD & N) 0.007% at
4dBu, 1kHz
Gain range ......................... 5dB to +60dB (MIC)
SNR (Signal to Noise Ratio) ... 105dB
Line input .......................... electronically balanced
Frequency response ............ 10Hz to 45kHz
Distortion (THD & N) ........... 0.01% at 4dBu, 1kHz
Sensitivity range ................. -26dBu to +26dBu
Stereo input Channels
Line input .......................... Balanced
Frequency response ............ 10Hz to 50kHz, +/-0.4dB
Distortion (THD & N) ........... 0.008% at +4dBu, 1kHz
Impedances
Microphone input ................ 4.5k Ohm
Channel Insert return .......... 2.5k Ohm
All other inputs ................... 14.8k Ohm or greater
Tape out ............................. 1k Ohm
All other output .................. 120 Ohm