Speco Technologies 4 - Manual (Page 70)

70
7-7-3. Device
Select Device to set Spot Out, Enable/Disable CVBS Out, motion zone.
1. Motion: Setup the motion detection area and the sensitivity.
- SITE: Select the channel
- MOTION ZONE: FULL Zone or PARTIAL Zone
- Motion Sensitivity: 1~9 (High sensitivity level)
2. Key Tone: Sets On or Off of Key Tone.
3. Remote Controller ID: Sets an ID number on the supplied remote control for its identification.
7-7-4. Display
Select the DISPLAY tab to set the DISPLAY conditions.
These settings apply to all channels.
1. OSD: Sets whether to display or not date and time as well as channel number on the screen.
2. OSD Contrast: Adjust the character contrast on the screen.
3. Sequence: Setting for automatically switching the displayed video.
4. Sequence-Dwell Time: Sets the interval for automatically switching the screens.
5. SITE: Name, Covert, Brightness, Contrast, Hue, Saturation
These settings apply to the specified channel only.