Sunbeam SC7500 - Manual (Page 4)

2
SAFETY PRECAUTIONS FOR YOUR
SUNBEAM ECO MOP.
• The Sunbeam Eco Mop is intended for
domestic household use only.
• Only use the attachments supplied with the
Eco Mop. Others may cause hazards.
• Always unplug the mop from the power outlet
when filling with water.
• Do not add detergents, chemicals, aromatic
products, or solutions of any kind when filling
the mop with water as this may damage the
mop or make it unsafe for use.
• The mop is switched on and heating once
connected and turned on at the power outlet,
even if the steam on/off switch is in the off
position ( ).
• Always use the tray when heating or cooling
or at any time the mop is stationary for more
than 10 seconds, to avoid damage to surfaces.
Should calcification occur, the white ‘halo’
effect can be removed using a decalcifying
product or with a few drops of vinegar applied
directly to the area.
• Do not direct the steam jet toward people or
pets as this could be harmful.
• Do not direct steam toward equipment
containing electrical components, such as
the interior of ovens. It could damage the
equipment and may cause serious injury.
• The safety pressure valve will automatically
activate if the steam pressure becomes too
high in the steam chamber. This can be
prevented by regular cleaning.
• Do not touch the lower part of the mop or the
attachments when the mop has been in use
as these parts will be hot. Allow to cool before
handling.
• Care must be taken when cleaning polished
wooden floor boards. Do not use the Eco Mop
on any unsealed wooden flooring, including
high traffic areas where the protective
coating may be worn down, as the steam may
penetrate and damage the wood. Steam may
also affect flooring that has been treated with
wax as it may be removed by the heat of the
steam, leaving the surface dull. If unsure,
spot test a small inconspicuous area before
proceeding.
• Always check the manufacturer's care and
cleaning instructions before using the Eco Mop
to clean fabrics, soft furnishings and other
surfaces, where possible.
• Do not use the utility head on any surface
without a cloth fitted as it may damage or
scratch the surface.
• Always ensure the mop is unplugged and
completely cool before cleaning the steam
chamber.
• Allow the mop to cool completely before
storing.
2
Safety Precautions for your
Eco Mop