Sony VAIO VGF-HS1 - Manual (Page 11)

11
VGF-HS1 3-98-361-11(1)
 Hardware connection and setup
Placing your Home Server
Unsuitable location
To prevent failures and damage, do not place your Home Server in a location subject to:

Direct sunlight

Magnetic sources

Heat sources, such as heaters

Excessive dust

High humidity

Poor ventilation
Precautions on placement
Keep the following in mind to place your Home Server.
Be sure to hold your Home Server on
both sides to lift.
Do not apply strong shock to your
Home Server when placing.
.0 inches
(.0 cm)
Allow clearance of at least .0 inches
(.0 cm) wide on either side of your
Home Server.
Keep the air-intake vents on the
bottom, the sides, and the back of
your Home Server unblocked.
Place the Home Server on a flat,
solid surface so as to let the air flow
under the bottom of the Home
Server.
.0 inches
(.0 cm)
Rear (unblocked)
.0 inches
(.0 cm)
.0 inches
(.0 cm)
Be sure to provide adequate air
circulation around your Home
Server to prevent internal heat from
building up, as it will cause your
Home Server to malfunction or
result in a fire. Keep the cooling fan
on the back and the air-exhaust
vents on the sides and the bottom
unblocked to let the air flow out.