SMC Networks SMC TigerStack IV SMC6224M User Manual
Management guide
Advertising
TigerStack 10/100
24/48-Port 10/100Mbps
Stackable Managed Switch
Management Guide
◆ 24/48 auto-MDI/MDI-X 10BASE-T/100BASE-TX ports
◆ 2 Gigabit RJ-45 ports shared with 2 SFP transceiver slots
◆ 2 Gigabit stacking ports that act as Ethernet ports in
standalone mode
◆ Stacks up to 8 units (SMC6224M)
◆ Stacks up to 4 units (SMC6248M)
◆ Non-blocking switching architecture
◆ Spanning Tree Protocol and Rapid STP
◆ Up to four LACP or static 8-port trunks
◆ RADIUS and TACACS+ authentication
◆ Rate limiting for bandwidth management
◆ CoS support for four-level priority
◆ Full support for VLANs with GVRP
◆ IP Multicasting with IGMP Snooping
◆ Manageable via console, Web, SNMP/RMON
Management Guide
SMC6224M
SMC6248M
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Chapter 1 Introduction
- Chapter 2 Initial Configuration
- Chapter 3 Configuring the Switch
- Using the Web Interface
- Navigating the Web Browser Interface
- Main Menu
- Basic Configuration
- Displaying System Information
- Displaying Switch Hardware/Software Versions
- Displaying Bridge Extension Capabilities
- Setting the Switch’s IP Address
- Managing Firmware
- Saving or Restoring Configuration Settings
- Console Port Settings
- Telnet Settings
- Configuring Event Logging
- Resetting the System
- Setting the System Clock
- Simple Network Management Protocol
- User Authentication
- Access Control Lists
- Port Configuration
- Address Table Settings
- Spanning Tree Algorithm Configuration
- VLAN Configuration
- Class of Service Configuration
- Multicast Filtering
- Chapter 4 Command Line Interface
- Using the Command Line Interface
- Entering Commands
- Command Groups
- Line Commands
- General Commands
- System Management Commands
- Flash/File Commands
- Authentication Commands
- Access Control List Commands
- SNMP Commands
- Interface Commands
- Mirror Port Commands
- Rate Limit Commands
- Link Aggregation Commands
- Address Table Commands
- Spanning Tree Commands
- spanning-tree
- spanning-tree mode
- spanning-tree forward-time
- spanning-tree hello-time
- spanning-tree max-age
- spanning-tree priority
- spanning-tree pathcost method
- spanning-tree transmission-limit
- spanning-tree spanning-disabled
- spanning-tree cost
- spanning-tree port-priority
- spanning-tree edge-port
- spanning-tree portfast
- spanning-tree link-type
- spanning-tree protocol-migration
- show spanning-tree
- VLAN Commands
- GVRP and Bridge Extension Commands
- Priority Commands
- Multicast Filtering Commands
- IP Interface Commands
- Appendix A Software Specifications
- Appendix B Troubleshooting
- Glossary
- Index