Siemens 383V FA - Manual (Page 30)

Colour monitor 383V FA
22 - English A26361-K873-Z100-2-5E19
No display (power indicator lights)
Ê Check whether the computer is switched on.
Ê Check whether the data cable for the monitor is correctly attached to the monitor port on the
computer.
Ê Press any key on the computer keyboard – the computer may be in energy saving mode.
Ê Alter the brightness and/or contrast until you get a picture.
Picture disturbances (vertical and horizontal lines, picture noise)
Ê First set the basic setting of the monitor with the floppy disk provided.
Ê If necessary, then adjust the picture definition with the FINE TUNE function ( LCD ADJUST
submenu).
i
If one of the operating systems Windows for Workgroups, Windows 95/98, Windows NT,
Windows Me, Windows 2000 or OS/2 (with Windows emulation installed) is used, the
basic monitor settings can be set with the floppy disk supplied.
Permanently unlit or lit pixels
The standard of production techniques today cannot guarantee an absolutely fault-free screen
display. A few isolated constant lit or unlit pixels may be present. The maximum permitted number
of pixels faults is stipulated in the stringent international standard ISO 13406-2 (Class II).
Example: a 15" flat-screen monitor with a resolution of 1024 x 768 has 1024 x 768 = 786432 pixels.
Each pixel consists of three subpixels (red, green and blue), so there are about 2.4 million dots in
total.
According to ISO 13406-2 (Class II), a maximum of 4 pixels and 5 subpixels may be defective, i. e.
a total of 17 faulted dots. This corresponds to approx. 0,002 % of the entire screen surface!
The flat screen monitors from Fujitsu Siemens Computers are typically considerably better than
requirements defined in this standard.
The screen becomes darker
The background lighting has a limited lifetime. If your monitor display should become too dark, the
background lighting will have to be exchanged. Please contact our Help Desk.