Sony PAM-200 - Manual (Page 6)

PAM-200
Page - 6 - Installation Manual
Ceiling Installation
1. Mounting Surfaces
NOTE: Use a 1/4” drill bit to pre-drill the mounting holes
before securing the wood screws (supplied).
Wood studs: Where denoted with the letter ‘A’, mark these
locations for wood stud installation.
NOTE: Use a masonry bit to pre-drill the mounting holes in
the concrete surface.
Concrete surface: Where denoted with the letter ‘B’, mark
these locations for concrete installation.
2. Use two (2) #14 x 2” wood screws (supplied) to attach the
ceiling plate to the wooden ceiling stud.
NOTE: For extra security, attach a third wood screw to the
middle mounting point (A).
3. Slowly raise the projector toward the upper assembly. Once
the projector is close to the upper assembly, MagnaGuide
Technology will pull the lower assembly into the upper
assembly and the locking tab will engage.
WARNING: THE MAGNETS ARE USED FOR GUIDING
THE UNIT ONLY! PLEASE MAKE SURE
THE TWO (2) M4 X 12MM SCREWS ARE
USED TO SECURE THE PROJECTOR.
4. Attach the two (2) M4 x 12mm security screws and
washers that are located on each side of the locking tab.
NOTE: Do not release your hold on the projector until the
upper and lower assemblies are engaged and the
locking tab is in place.
NOTE: If you choose to use the center mounting point for
added security, detach the adjustable suspension neck
by removing the two (2) M6 x 12mm security screws,
drive the wood screw in place and reattach the
adjustable suspension neck and security screws.
After the projector has been installed, the projector must then be
adjusted. To adjust the projector:
1. Loosen the M5 set screw using the M5 Allen wrench (both
sides).
2. Adjust the projector to the correct position. Firmly grasp the
projector in both hands, and tilt either forward or
backward to adjust the level.
-OR-
Firmly grasp the projector in both hands and rotate side to
side for orientation adjustment.
3. Tighten the M5 set screw on both sides using the M5 Allen
wrench.
Height Adjustment
1. To adjust the height of the PAM-200, hold the weight of the
projector and loosen the two (2) M6 x 12mm security
screws.
2. Slide the adjustable suspension neck into the desired
position.
3. Retighten the two (2) M6 x 20mm security screws.
NOTE:
Do not release the projector until the M6 screws are
completely tight.
M5 Set Screw
M6 x 20mm
Security Screws
M4 x 12mm Security
Screw and Star Washer
M6 x 12mm
Security Screw
M5 Allen
Wrench
Adjustable
Suspension Neck