Smeg LSA6047X - Manual (Page 10)

User instructions

ANNULLING A PROGRAM
To annul the program in progress, it must first be interrupted (see
“I
NTERRUPTION OF A PROGRAM ”).
Now press buttons P1+P2 simultaneously and
the first three program lights will come on.
In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph “S
TART PROGRAM ”. The program will resume from the point in
which it was interrupted.
In case that the tub temperature is higher than 50°C the program
will start about 30 seconds later.
The washing cycle will not take place if the dishwasher door is left open
or not properly closed.
HALF LOAD WASH FUNCTION (on some models only)
Pressing button ½ LOAD WASH (4) selects washing on the top basket
only.
After selecting the program, proceed as follows:
• press the button ½ LOAD WASH (4) once to select the top basket
(the relative light comes on);
• press the button ½ LOAD WASH (4) again to return to full load
wash status (the light goes out).
The ½ LOAD wash option can be selected in all programs except the
soak program.
N.B.: selecting the ½ LOAD option changes the duration of the program.
It is possible to place a cutlery basket inside the basket selected for the
HALF-LOAD program; the other basket must remain empty.
WARNING: do not load dishes and cutlery into the non-selected
basket, because the water spray will only reach the selected basket.