Sony CPD-E500 - Manual (Page 6)

6
Setup
Before using your monitor, check that the following accessories
are included in your carton:
• Power cord (1)
• Macintosh adapter (for beige system) (1)
• Setup Disk (1)
• Warranty card (1)
• Notes on cleaning the screen’s surface (1)
• This instruction manual (1)
Step 1: Connect your monitor to
your computer
Turn off the monitor and computer before connecting.
Note
Do not touch the pins of the video signal cable connector as this might
bend the pins.
x
Connecting to an IBM PC/AT or compatible
computer
x Connecting to a Macintosh or compatible
computer
* Connect the supplied Macintosh adapter to the computer before
connecting the cable.
This adapter is compatible with Macintosh LC, Performa, Quadra,
Power Macintosh, and Power Macintosh G3 series computers that have
two rows of pins. If you are connecting to the other version of Power
Macintosh G3 series with three rows of pins or models other than those
stated above, you will need a different adapter (not supplied).
Step 2: Connect the power cord
With the monitor and computer switched off, first connect the
power cord to the monitor, then connect it to a power outlet.
AC IN
to video output
IBM PC/AT or compatible
computer
AC IN
Macintosh adapter (for beige system)
(supplied)
*
Macintosh or
compatible computer to video
output
AC IN
to AC IN
to a power outlet
power cord (supplied)