SVAT Electronics GX5204 - Manual (Page 6)

GX5204 3
SVAT ELECTRONICS
now you can see
INST INST ALLING THE CAMERA ALLING THE CAMERA
1. Unpack the camera.
2. Decide whether the camera will be wall-mounted or sit on a desk/table top. If wall
mounting, use the mounting hardware. The camera can be adjusted for either
mounting scenario by rotating the camera to the required position.
3. Decide whether to connect using AC power or 9 volt battery. If using a battery,
connect the 9V battery to the battery adapter, then connect it to the power jack of
the camera. If using the camera power adapter, just connect the power jack. Make
sure the camera is positioned no more than 5 1/2 feet from an AC power outlet.
4. Select the camera operating channel on the slide switch on side of the housing.
Move the switches to positions 1,2, or 3.
The camera (Transmitter) installation is now complete.
INST INST ALLING THE LCD MONIT ALLING THE LCD MONIT OR OR
Main Operation
1. Plug the monitor's power supply into the power jack located inside the battery
compartment of the monitor. The monitor can also be operated using 4-AAA batteries.
Note: It is recommended that you use the provided AC adapter to power the monitor.
Batteries are recommended for portability and can last up to 200 minutes.
2. Turn on the monitor by pressing the power button on the top of the unit.
3. To connect the monitor to a VCR or DVR for recording purposes, use the 3.5mm to
RCA wire and connect the appropriate end to the A/V output port on the monitor, and
the other corresponding ends to the audio and video inputs of the VCR/DVR.