Skil 2372 User Manual

Page 6

Advertising
background image

-6-

When batteries are not in

tool or charger, keep them

away from metal objects. For example, to
protect terminals from shorting

DO NOT

place batteries in a tool box or pocket with

nails, screws, keys, etc. Fire or injury may
result.
DO NOT PUT BATTERIES INTO FIRE OR

EXPOSE TO HIGH HEAT. They may
explode.

!

WARNING

Battery Care

Charging the Tool

When the battery is empty, the tool is
switched off by means of a protective circuit:
The tool no longer operates.

To prevent damage to

battery, do not continue to

press the On/Off switch after the tool has
been automatically switched off.

The battery is supplied partially charged.
Completely charge the battery before using
your power tool for the first time. The lithium
ion battery can be charged at any time
without reducing its service life. Interrupting
the charging procedure does not damage the
battery.

A battery that is new or has not been used
for a longer period does not develop its full
capacity until after approx. 5
charging/discharging cycles.

1. Insert the connector pin into hole provided
in rear end of handle, then plug the charger
into the power source (Fig. 1)

During the charging procedure, the handle of
the tool warms up. This is normal.

Disconnect the battery charger from the
power supply when not using it for longer
periods.

To prevent damage to

charger, do not run the

tool with the charger connected.

FIG. 1

CONNECTOR PIN

!

CAUTION

!

CAUTION

Do not recharge battery in damp or wet

environment. Do not expose charger to rain

or snow. If battery case is cracked or

otherwise damaged, do not insert into

charger. Battery short or fire may result.
Charge only Skil approved rechargeable

batteries. See Functional Description and
Specifications. Other types of batteries may
burst causing personal injury and damage.
Charge battery pack in temperatures above

+32 degrees F (0 degrees C) and below

+113 degrees F (45 degrees C). Store tool

and battery pack in locations where

temperatures will not exceed 120 degrees F

(49 degrees C). This is important to prevent
serious damage to the battery cells.
Battery leakage may occur under extreme

usage or temperature conditions. Avoid

contact with skin and eyes. The battery

liquid is caustic and could cause chemical
burns to tissues. If liquid comes in contact with
skin, wash quickly with soap and water. If the
liquid contacts your eyes, flush them with water
for a minimum of 10 minutes and seek medical
attention.
Place charger on flat non-flammable

surfaces and away from flammable

materials when re-charging battery pack.
The charger and battery pack heat during
charging. Carpeting and other heat insulating
surfaces block proper air circulation which may
cause overheating of the charger and battery
pack. If smoke or melting of the case are
observed unplug the charger immediately and
do not use the battery pack or charger.
Use of an attachment not recom-

mended or sold by Skil may result in a risk

of fire, electric shock or injury to persons.

SM 1619X03291 05-08 5/28/08 1:52 PM Page 6

Advertising