StarTech.com StarView SV431USB - Manual (Page 10)

8
For SV231USB
To activate the Auto Scan, press and hold the
pushbutton down for 2 seconds until you hear a long
beep followed by a short beep. To exit from it, tap the
pushbutton again.
To change the Scan Time interval, press and hold the
pushbutton for 4 seconds until you hear two long beeps.
By tapping the pushbutton each time, the SV231USB
responds with 1, 2, 3 or 4 beeps corresponding to 3, 8,
15 or 30 seconds respectively. Once set, leave the
SV231USB as it is and it will automatically return for
normal operation.
For SV431USB
To activate Auto Scan, press down front panel push
buttons “3” and “4” simultaneously. The port LED flashes
during Auto Scan. Auto Scan is effective for powered-on
computers only. To exit the Auto Scan mode, just tap any
one of the pushbuttons.
To change the Scan Time interval, press both front panel
buttons “1” and “2” simultaneously. The Sv431USB
beeps 1, 2, 3 or 4 times for Scan Time of 3, 8, 15 or 30
seconds respectively.