Specifications, Troubleshooting, Additional information – Sony CDP-CE515 User Manual

Page 27

Advertising
background image

Additional Information

Additional Information

Additional Information

27

EN

Specifications

Compact disc player

Laser

Semiconductor laser (

λ

= 780 nm)

Emission duration: continuous

Laser output

Max 44.6

µ

W*

* This output is the value measured at

a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.

Frequency response

2 Hz to 20 kHz ±0.5 dB

Signal-to-noise ratio

More than 107 dB

Dynamic range

More than 98 dB

Harmonic distortion

Less than 0.0035%

Output

Troubleshooting

If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.

There’s no sound.

/Check that the player is connected securely.
/Make sure you operate the amplifier correctly.
/Adjust the playback level using the LINE OUT

LEVEL +/– buttons on the remote.

The CD does not play.

/There’s no CD inside the player (“–NO DISC–”

appears). Insert a CD.

/Place the CD with the label side up on the disc

tray correctly.

/Clean the CD (see page 26).
/Moisture has condensed inside the player.

Remove the disc and leave the player turned on
for about an hour (see page 26).

/Place the CD in the correct position on the disc

tray.

The remote does not function.

/Remove the obstacles in the path of the remote

and the player.

/Point the remote at the remote sensor g on the

player.

/Replace all the batteries in the remote with new

ones if they are weak.

/Set the CD 1/2/3 switch on the remote

according to the position of the COMMAND
MODE selector at the rear panel of the player.

The player functions incorrectly.

/The microcomputer chips may be operating

incorrectly. Turn the power off, then turn it
back on to reset the player.

LINE OUT

DIGITAL OUT
(OPTICAL)

PHONES

Jack
type

Phono
jacks

Optical
output
connector

Stereo
phone jack

Maximum
output
level

2 V
(at 50 kilohms)

–18 dBm

10 mW

Load
impedance

Over 10 kilohms

Wave length: 660 nm

32 ohms

General

Power requirements

Where purchased

Canada

Europe

Power consumption

14 W

Dimensions (approx.)

430

Ч

120

Ч

393 mm

(w/h/d)

(17

Ч

4 3/4

Ч

15 1/2 in.) incl. projecting

parts

Mass (approx.)

5.4 kg (11 lbs 15 oz)

Supplied accessories

Audio cord (2 phono plugs – 2 phono plugs) (1)
Remote commander (remote) (1)
Sony SUM-3 (NS) batteries (2)

Design and specifications are subject to change without notice.

Power requirements

120 V AC, 60 Hz

220 V – 230 V AC, 50/60 Hz

Advertising