Sony DVP-NS415 - Manual (Page 63)

63
Set
tings
a
nd
Adj
u
st
m
e
nt
s
◆ DOWNMIX (DVD only)
Switches the method for mixing down to 2
channels when you play a DVD which has
rear sound elements (channels) or is recorded
in Dolby Digital format. For details on the
rear signal components, see “Checking the
audio signal format” (page 44). This function
affects the output of the following jacks:
– LINE OUT L/R (AUDIO) jacks
– DIGITAL OUT (OPTICAL or COAXIAL)
jack when “DOLBY DIGITAL” is set to
“D-PCM” (page 63).
◆ DIGITAL OUT
Selects if audio signals are output via the
DIGITAL OUT (OPTICAL or COAXIAL)
jack.
Setting the digital output signal
Switches the method of outputting audio
signals when you connect a component such
as an amplifier (receiver) or MD deck with a
digital input jack.
For connection details, see page 20.
Select “DOLBY DIGITAL,” “MPEG,” and
“DTS” after setting “DIGITAL OUT” to
“ON.”
If you connect a component that does not
conform to the selected audio signal, a loud
noise (or no sound) will come out from the
speakers, affecting your ears or causing the
speakers to be damaged.
◆ DOLBY DIGITAL (DVD only)
Selects the type of Dolby Digital signal.
◆ MPEG (DVD only)
Selects the type of MPEG audio signal.
DOLBY
SUR-
ROUND Select this when the player is
connected to an audio
component that conforms to
Dolby Surround (Pro Logic).
NORMAL Select this when the player is
connected to an audio
component that does not
conform to Dolby Surround (Pro
Logic).
ON Normally select this position. When
you select “ON,” see “Setting the
digital output signal” for further
settings.
OFF The influence of the digital circuit
upon the analog circuit is minimal.
AUDIO SETUP
AUDIO ATT:
AUDIO DRC:
DOLBY DIGITAL:
MPEG:
OFF
STANDARD
DOWNMIX: DOLBY SURROUND
D-PCM
PCM
DTS: OFF
DIGITAL OUT: ON
D-PCM Select this when the player is
connected to an audio
component lacking a built-in
Dolby Digital decoder. You can
select whether the signals
conform to Dolby Surround
(Pro Logic) or not by making
adjustments to the
“DOWNMIX” item in
“AUDIO SETUP” (page 62).
DOLBY
DIGITAL Select this when the player is
connected to an audio
component with a built-in
Dolby Digital decoder.
PCM Select this when the player is
connected to an audio
component lacking a built-in
MPEG decoder. If you play
MPEG audio sound tracks, the
player outputs stereo signals
via the DIGITAL OUT
(OPTICAL or COAXIAL)
jack.
MPEG Select this when the player is
connected to an audio
component with a built-in
MPEG decoder.
, continued