Sony DVP-CX875P - Manual (Page 17)

E:\3077145111DVPCX875P\01US05GET1-
UC.fm master page=right
DVP-CX875P
3-077-145-11(1)
17
S
im
p
le
S
ta
rt
Gu
id
e
Step 2: Preparing the
Remote
You can control the player using the supplied
remote. Insert two Size AA (R6) batteries by
matching the 3 and # ends on the batteries
to the markings inside the compartment.
When using the remote, point it at the remote
sensor
on the player.
Notes
• Do not leave the remote in an extremely hot or
humid place.
• Do not drop any foreign object into the remote
casing, particularly when replacing the batteries.
• Do not expose the remote sensor to direct light
from the sun or a lighting apparatus. Doing so
may cause a malfunction.
• If you do not use the remote for an extended
period of time, remove the batteries to avoid
possible damage from battery leakage and
corrosion.
When you have more than one Sony DVD
player
If the supplied remote interferes with your
other Sony DVD player, set the command
mode for this player and the supplied remote
to one that differs from the other Sony DVD
player.
The default command mode setting for this
player and the supplied remote is DVD1.
1
Slide the COMMAND MODE switch on
the remote to select the command mode
(DVD 1, DVD 2, or DVD 3) so that the
setting for the remote differs from the
other DVD players.
For example, if other DVD players
respond to the default command mode
setting for the supplied remote (DVD 1),
set the remote to DVD 2 or DVD 3.
2 Slide the COMMAND MODE switch on
the rear of the player so it matches that of
the supplied remote.