Sony RM-VL710 - Manual (Page 18)

18
2
Press and hold the
Component Select button
for the component whose
signals are to be “learned”
for over 3 seconds.
Then, SET indicator and all
other Component Select
buttons light.
When the SET indicator lights
up, you can release the
Component Select button. Both
the SET indicator and the
selected Component Select
button flash (Learning function
standby).
If another signal has already
been “learned” by that
button
The SET indicator flashes twice,
and the Commander takes no
action, returning to its state after
SET was pressed and held in Step 2.
Either “teach” to another free
button, or clear the already
“learned” function (page 20) and
start over from the beginning.
SET
CBL DVD AMP TV VCR
SET
CBL DVD AMP TV VCR
Programming signals of another
remote control — Learning
Function (continued)
Programming remote
control signals to the
Component Select buttons
You can “teach” one operating
procedure to a Component Select
button, so that when you press the
Component Select button, the
operation is also automatically
done.
For example, if it is necessary to
switch the input selection of an
amplifier to DVD when you use a
DVD player, “teach” an input
select signal to the DVD button.
After “learning”, the input
selection of an amplifier is
automatically switched to DVD
just by pressing DVD. (For this
operation, an amplifier should
first be turned on.)
Example: To “teach” the DVD
input remote control signal of
your amplifier to the DVD
Component Select button of the
Commander
1
Follow Steps 1 to 2 (page
14).