Service, Specifications – Soundstream Technologies Picasso User Manual

Page 10

Advertising
background image

Your

amplifier is protected against both overheating and short circuits

by means of the following circuits:

Main Power fuse

Smart Power Supply Thermal Rollback activating at

A failsafe thermal protection circuit activating at

NOTE: If you experience blown main power supply fuses, it is
that the amplifier is seeing a
dead short, either in the speaker wire or
in the speaker itself. Rectify the problem before blowing multiple
fuses! DO NOT increase values beyond the original fuse value!
Doing so will void your warrant and may damage your amplifer.

PROBLEM

CAUSE

No power or ground at the amp

No sound and the power LED is not lit.

2. No remote turn-on signal

3. Blown fuse near

battery

Repeatedly blown amp fuse; frequent

1. Speaker leads may be shorted

activation of the Smart Power Supply

2. Verify adequate amplifier ventilation

Circuit

3. Make sure you aren’t driving

No output from channels

with 1

Set the Ch

input selector swith on

pair of RCA inputs (Picasso only)

the top of the amp to “Ch

Not enough input sensitivity while using

Be sure both Left and Right input signal

Balanced DIN Input

switches are set to the

position.

Output signal level is too high and the

Left and Right “Clip” indicators lighting

amplifier output is clipping. Reduce the
level either at the source or with the
input level controls.

Alternator whine while using
Unbalanced RCA inputs

Make sure the channel 2 Input Signal

Switch is in the “UNBAL” position.
2. Try the Input Signal Switches for
channels 1, 3

4 in the

position:

leave the switches in the quitest
position. This will not effect the
performance of the amp.

SERVICE

Your

Class A amplifier is protected by a limited

warranty. Please read

the

enclosed warranty card for details.

SPECIFICATIONS

4

Stereo

2

Stereo

Maximum

POWER

(8 Bridged)

(4 Bridged)

Rated

(12.5 Vdc)

(12.5 Vdc)

output

x 2)

x 2)

200 Watts

THD
Signal to Noise

%

Frequency Response

Stereo Separation
Damping
Input Sensitivity

Input

Impedance

20 Hz to 20

0.5

300

to 5.0 Volts

1

Ok

Ohms

Dimensions (W x D x H)

16.0” X 9.8” X 2.25”

12.25” X 9.8” X 2.25”

19

18

Advertising