Snapper 1721302-04 - Manual (Page 20)

19
Reinforcement Bracket Installation
INSTALL REINFORCEMENT
BRACKET
NOTE: This kit applies to the Landlord / 1700 / 2700
Series hydraulic lift models only.
1. Loosen the four capscrews (A, Figure 32) securing
the quadrant (B) to the footrest.
2. Insert the reinforcement bracket (B, Figure 31)
between the quadrant (B, Figure 32) and foot rest.
Align the hole in the bracket with the square hole (A,
Figure 33) in the frame.
3. Secure the bracket (B, Figure 31) to the frame using
a 5/16-18 x 3/4 carriage bolt (A), washer (C), lock-
washer (D), and nut (E).
4. Tighten the quadrant hardware (A, Figure 32).
Figure 31. Support Bracket
A. Carriage Bolt, 5/16-18 x 3/4
D. 5/16 Locknut
B. Support Bracket E. 5.16-18 Nut
C. 5/16 Washer
Figure 33. Right Side Foot Rest
A. Support Bracket Hole
Figure 32. Lift Quadrant
A. Capscrews
B. Quadrant
B
A
C D
E
A
A
B