Sony WEGA KV-27FS210 - Manual (Page 22)

14
Operating Instructions
Connecting Additional Equipment
Connecting a TV and VCR
1
Connect the coaxial cable from your TV antenna or cable service to the IN jack on your
VCR.
2
Connect a coaxial cable (not supplied) from the OUT jack on your VCR to the VHF/UHF
jack on the TV.
Optional connection
❏ If your VCR is equipped with video outputs, you can get better picture quality by
connecting audio/video cables (not supplied) from AUDIO/VIDEO OUT on your VCR to
AUDIO/VIDEO IN on your TV.
❏ For better picture quality, use S VIDEO instead of the yellow video cable. S VIDEO does
not provide sound, so you still must connect the audio cables.
Using your TV with this connection
This connection allows you to do the following:
❏ Program your Sony remote control to operate your VCR (see page 5).
❏ To activate your remote, press to operate your VCR. To do this, first program your
remote control, then use the Channel Fix feature to set your TV to channel 3 or 4 (see page 31).
❏ Press repeatedly to switch between VCR input (VIDEO input) and VHF/UHF
(local channels).
Optional connection
VCR
2
1
1 3 4 AUDIO OUT
(VAR/FIX)
VIDEO
L
(MONO)
R
L
R
(MONO)
S VIDEO
Y
P B
P R
5
Video (yellow)
Audio R (red)
Audio L (white)
From
cable/antenna
Rear of TV