Spectrum Brands 72A-196BAREM Series - Manual (Page 17)

Installation and Operation Manual
Date: 6/02/2008 17
27-0027-0111
SCI P/N: 72A-196BAREM Series
72A-190BQREM Series
Networking Functions
The PDU LAN Port supports the Telnet and SNMP networking functions,
which allow remote monitoring through the network environment. Table
1 lists the available Telnet commands. Table 2 lists the content of SNMP
functions – Read/Set/Trap in detail. An SNMP Manager PC Tool is need-
ed in order to implement the SNMP functions. To implement the Telnet
and SNMP functions, the device must be configured properly, such as
assigning a valid IP address or subnet mask by using the recommended
device discovery tool.
Telnet always has the higher priority than SNMP with the timeout value of
30 seconds, which can be adjusted later.
Introduction
Telnet
Communication
You can access the PDU by typing “telnet <IP> 10001” and entering the
username and password (Default username is “root”. Default password is
“1234”). The telnet session has a 30 second timeout.
A list of commands is in the following table.