Sony SPM-TRI/C - Manual (Page 2)

- 2 -
o
Safety & precautions
o
Mount diagrams
o
Parts List
o
Building the stand
o
Securing the plasma to the stand
o
Tabletop fixed installation (optional)
The floor or tabletop must be capable of supporting at least five (5) times the weight of plasma display. If not, the floor or tabletop must be
reinforced. Proper installation procedure by qualified personnel as outlined in the installations instructions must be adhered to. Failure to do
so could result in serious personal injury
The entire installation instructions should be fully read and understood, including all of the safety symbols and safety precautions before
beginning installation. The installation instructions should be read, understood and followed to prevent personal injury or property damage.
Keep these installation instructions in an easily accessible location for future reference.
Indicates that the power plug is to be disconnected from
the power outlet.
Safety precautions must be taken at all times.
Contact Sony for any questions
Warning and caution in general
Do not install near heater, fireplace, direct sunlight or air conditioning or any other source of direct heat energy. Failure to do so may
result in damage to the plasma display and could cause a risk of fire.
At least two qualified people should always perform the installation work. Injury and damage can result from dropping or mishandling
the plasma display.
Contents
Safety & Precautions
WARNING : Safety precaution measures must be practiced at all times during the installation of this product. Use proper safety gear and tools for the
installations procedure to prevent personal injury or damage to the plasma display or plasma mount.