Sony Ericsson DSC-S600 - Manual (Page 5)

Remove Shutter Board
Next carefully turn the shutter board plastic housing
upside down and remove the tabs holding the shutter
board to the plastic housing as shown.
Lift out the shutter board and turn upright.
Locating the Shutter/Power/Common Contacts
The PixController board contact points are shown in
Figure 3. These are the locations where you will
solder your small gauge wire and will be connected
to your PixController board.
You will need a fine tipped soldering iron in order to
perform this task. You may need to remove some of
the fine plastic covering around the Power On/Off
and Common contacts with a tool like and Exacto
Knife.
Figure 3
Add the wires…
Add the small gauge wires as shown in Figure 4
Figure 4