Samsung MM-DX7 - Manual (Page 25)

Timer Function
• The timer enables you to switch the system on or off at specific times.
• If you no longer want the system to be switched on or off automatically, you must cancel the timer.
• Before setting the timer, check that the current time is correct.
• For each step, you have a few seconds to set the required options.
If you exceed this time, you must start again.
Example: You wish to wake up to music every morning.
• ON TIME is displayed (instead
of the equalizer symbols) for a
few seconds, followed by any
switch-on time already set; you
can set the timer switch-on time.
• The source to be selected is
displayed.
2 1 3 Switch the system
on by pressing
POWER.
Press
TIMER/CLOCK
until
TIMER is
displayed.
Press the ENTER
button.
• is displayed to the top-right
of the time, indicating that the
timer has been set.
• The system will switch on and off
automatically at the required
times.
8 7 9
Press or button
to select the source to
be played when the
system switches on.
Press ENTER to
confirm the timer.
Press POWER to
set the system to
standby mode.
5 4
a. Set the hour by pressing or
button.
b. Press ENTER.
• The minutes flash.
c. Set the minutes by pressing or
button.
d. Press ENTER.
• OFF TIME is displayed (instead
of the equalizer symbols) for a few
seconds, followed by any switch-
off time already set; you can now
set the timer switch-off time.
• TAPE (cassette) : Insert a cassette
tape.
• TUNER (radio) : a Press ENTER.
b Select a preset
station by pressing
Tuning or .
• CD (compact disc) : Load a compact
disc.
• USB :Connect the USB.
a. Set the hour by pressing or
button.
b. Press ENTER.
• The minutes flash.
c. Set the minutes by pressing or
button.
d. Press ENTER.
• VOL 10 is displayed, where 10
corresponds to the volume
already set.
Set the timer
switch-off time.
6
Press or button
to adjust the volume
level and press
ENTER.
Set the timer
switch-on time.
Note
• If the timer switch on and off times are identical, the word ERROR is displayed.
47 48
Selecting the cassette Playback
Mode/Repeat A
↔B /Tape Counter
Function
• Use this to listen to a specific section again during playback.
• Set the start and end points of the section you want to repeat 3 times.
• This is a useful when learning a foreign language.
• The TAPE REPEAT function can be used only on sections that are longer
than 7 seconds.
Press REPEAT A ↔B button.
• You cannot set the end point (B) within 7 seconds after setting the start point (A).
• Repeat A-B Function is available for TAPE only.
Note
MISCELLANEOUS
REPEAT A ↔B Function
Press REVERSE MODE until the appropriate
symbol is displayed.
• : One side of the selected cassette and then stops.
• : One side of the cassette.
The other side of the cassette and then stops.
• : Both sides of the cassette indefinitely until you
press stop.
Your micro component system has three cassette playback modes which
enable you to listen to both sides of a cassette automatically. .
Selecting the Cassette Playback Mode
• Before starting to record a cassette for which you wish to take
note of the counter values at the beginning of each track, reset
the counter by pressing and hold COUNTER RESET .
When playing cassette, a counter is displayed to enable you to
take note of the counter value at the start of each track to start
playback at the beginning of the track to which you wish to listen.
Tape Counter
MM-DX7(31p~64p)-GB-NO-4 4/12/07 9:43 Page 46