Sony HDW-S2000 - Manual (Page 15)

Chapter 2
Location and Function of Parts
Chapter 2 Location and Function of Parts
2-5
1 Audio control section
1 Audio selection function selector buttons
INPUT (input signal selection mode) button:
Pressing this button puts the unit into input signal
selection mode. In the audio setting display
section, indicators flash to indicate the currently
selected signal for each channel (HDSDI, SDTI,
AES/EBU, or ANA). In this state, you can use the
audio monitor signal selection buttons to select the
signal to input to each channel.
Pressing this button again takes the unit out of
input signal selection mode and puts it into
monitor signal selection mode.
MIXING (mixing setting mode) button: Pressing
this button puts the unit into mixing setting mode.
In the audio setting display section, the MIX
indicator flashes. In this state, you can use the
audio monitor signal selection buttons to specify
which input channel signal will be recorded on
which audio track on the tape.
Pressing this button again takes the unit out of
mixing setting mode and puts it into monitor
signal selection mode.
For information about how to operate in input signal
selection mode, mixing setting mode, and monitor signal
selection mode, see the descriptions of the audio monitor
signal selection buttons 4 on page 2-6.
1 Audio selection function selector buttons
2 DISPLAY FULL/FINE button
Pressing this button toggles the display mode of the
level meters in the audio setting display section
between FULL and FINE.
FULL: The display covers the range –60 dB to 0 dB
or –40 dB to +20 dB as selected using setup menu
item 806. In this mode the segment of the display
corresponding to the current audio level and all
lower segments light.
FINE: The display is enlarged, with a step of
0.25 dB. A segment indicating the reference level
lights. In this mode only the segment of the
display corresponding to the current audio level
lights. If the audio level exceeds the maximum
display level, the top segment flashes, and if the
audio level goes below the minimum display
level, the bottom segment flashes.
3 Audio setting display section
Input signal indicator: Indicates the currently
selected input signal (HDSDI, SDTI, AES/EBU,
or ANA for analog) for the corresponding audio
input channel.
MIX (mixing) indicator: Flashes when a mixing
setting operation is enabled for the corresponding
audio track. The indicator showing the number of
the selected input channel lights.
2 DISPLAY FULL/FINE button
3 Audio setting display section
4 Audio monitor
signal selection
buttons
5 REC controls
6 PB controls
5 6 7 8
HDSDI SDTI
AES/EBU/ANA
DATA
MIX 1 2 3 4
OVER dB dB
EMPH L R
20
10
2
1
0
0
-10
-20
-30
-40
-60
-1
-10
-20
-40
-2
Input signal indicator
DATA indicator
MIX indicator
OVER indicator
Level meter
Input channel
indicator
Monitor channel L
and R indicators
EMPH indicator