Samsung CLP 510N - Manual (Page 19)

Synchronization Mode
Two synchronization modes are available Internal and
External linelock. -In linelock mode, it synchronizes the video
signal between cameras without a synchronous generator.
The linelock synchronization is only used in the areas of
60Hz(NTSC Models)/50Hz(PAL Models).
1. Press the SET button to display the setup menu and move the arrow
indicator to 'Sync.' using the UP or DOWN button.
2. Select 'LL' or 'INT' using the LEFT or RIGHT button.
INT : Internal synchronization.
LL : External linelock synchronization.
Color ( Day & Night)
Your camera provides automatic mode changeover by sensing day
or night conditions. It changes to Color mode in day conditions for
optimal color and to BW mode in night conditions for clear
identification.
1. Press the SET button to display the setup menu and move the arrow
indicator to 'Color' using the UP or DOWN button.
2. Select a mode using the LEFT or RIGHT button.
ON : Color mode is kept up.
OFF : A black and white mode is kept up.
Auto1 : Select this mode under a normal light source(sunlight or
fluorescent lamp). When changing between color and
B/W, the OSD key does not act for 3 seconds.
Auto2 : Select this mode under light source that have a wavelength
range mostly above 800nm(incandescent lamp). When
changing between color and B/W, the OSD key does not
act for 3 seconds.
3. L.L mode Press the SET button.
3. Press the SET button.
Setup
Camera ID OFF
Backlight OFF
Motion Detect. OFF
Lens DC
Shutter ESC
Gain AGC
White Balance
ATW
Color Auto1
Sync. LL
Reset
End
Setup
Camera ID OFF
Backlight OFF
Motion Detect.
OFF
Lens DC
Shutter ESC
Gain AGC
White Balance
ATW
Color Auto1
Sync. LL
If you set low level in Video IRIS mode, Color/BW may not change over
automatically.
Under Gain OFF Color/BW does not change over automatically, ON/OFF is
only available.
If you change ‘Gain’ menu from ON to OFF, ‘Color’ mode change to ON.
If you change ‘Gain’ menu from OFF to ON, ‘Color’ mode change to Auto1.
Select Auto2 in ‘Color’ mode under incandescent lamp.
Adjust the focus if the camera is out of focus for changing modes. NOTE
Notes
36 37
COLOR CCD CAMERA COLOR CCD CAMERA
S S E ET TU UP P M M E EN NU U S S E ET TU UP P M M E EN NU U