Sony 3-270-589-12 (1) - Manual (Page 120)

120
Troubleshooting
A
ppen
dix
a) Displayed only when DISPLAY CONTROL >ALARM is set to “ON”. b) Displayed only when DISPLAY CONTROL >ALARM is set to “ON” or
“LIMITED”.
During recording and editing operations
a) Displayed only when DISPLAY CONTROL >ALARM is set to “ON” or
“LIMITED”.
Alarm message in time
data display section Alarm message in monitor video
section Description/action
Input Sig!”
a) INPUT SIGNAL FREQUENCY IS NOT
THE SAME AS THE SYSTEM SETUP. This appears when an input signal does not match
the system frequency of this unit.
Input a signal that matches the system frequency, or
change this unit's system frequency setting
(see page
27).
HD 60I/30P
a) DISC CANNOT BE RECORDED. HD 60I
or HD 30P CLIP(S) EXIST. This appears when the system frequency of this unit
does not match that of the loaded disc.
Insert a disc that matches the system frequency, or
change this unit's system frequency setting
(see page
27).
HD 50I/25P
a) DISC CANNOT BE RECORDED. HD 50I
or HD 25P CLIP(S) EXIST.
HD 23P Disc
a) DISC CANNOT BE RECORDED. HD
23.98P CLIP(S) EXIST.
ILL. REF!
a) INPUT VIDEO SIGNAL DOES NOT
SYNCHRONIZE WITH REF VIDEO
SIGNAL.
USE COMMON REFERENCE SIGNAL
OR CONNECT RECORDER REF OUT TO
PLAYER REF IN. Input a reference signal synchronized with this unit’s
system frequency.
ILL. REC!
a) ENCODING DOES NOT SYNCHRONIZE
WITH REF VIDEO. Check the signals being input to this unit.
ILL. PLAY!
a) ILLEGAL PLAYBACK. Check the disc being played by this unit.
MEM. Full!
a) MEMORY FULL !! Check the disc being recorded by this unit.
MEM. Empty!
a) MEMORY EMPTY !!
Recording NOW RECORDING ... Wait for recording to finish.
Drive Busy! PREVIOUS CLIP HAS NOT BEEN
RECORDED ON TO THE DISC
YET.STOP RECORDING AND WAIT TILL
THE ACCESS LED TURN OFF. This appears when a clip has been saved to this unit’s
temporary memory but recording to the disc has not
been completed. Wait until recording to the disc
finishes (until the ACCESS indicator turns off).