Sony SAT-B3 - Manual (Page 73)

73
Step 2: Set the Remote Control’s RF Security Code
1
Press the CODE SET button on the remote control.
2
Using the number buttons on the remote control, enter the three-
digit security code you selected for the Digital Satellite Receiver in
step 2 on page 72.
3
Press the ENTER button on the remote control.
The RF security code is now changed for both the Digital Satellite
Receiver and remote control.
To Determine the Current
Security Code for the
Remote Control
(SAT-A4 Only) You can determine the current RF security code for the remote control
using the IDENTIFY button in the Set Up Remote screen.
1
Bring up the Set Up Remote screen, as described on page 71.
2
Select IDENTIFY.
3
When the message “Press the joystick within 5 seconds” appears,
press the joystick before the 5 seconds expire.
The current RF security code for the remote control appears.
Note
If the message, “Security code could not be identified” appears, check to make
sure that RF is enabled and that the RF antenna is connected properly. See
“Selecting IR/RF Transmission (SAT-A4 Only)” on page 71.
4
Select OK to return to the Setup Menu.
Press the joystick within 5 seconds.
SET UP REMOTE
REMOTE SIGNAL
RF SECURITY CODE
IR ONLY
000
OK
CANCEL
IDENTIFY
HELP
REMOTE CODES
Your remote is currently set at 000.
SET UP REMOTE
REMOTE SIGNAL
RF SECURITY CODE
IR ONLY
000
OK
CANCEL
IDENTIFY
HELP
REMOTE CODES